Sega Sega Rally 2 Bedienungshandbuch PDF herunterladen (Seite 56)

13-3 TOSHIBA PROJECTOR

Do not touch places other than those specified. Touching places not

specified can cause an electric shock or short circuit accident.

TOSHIBA PROJECTOR has two different types, i.e., one equipped with the Control Panel

and the other without the Control Panel. When adjusting, be sure to confirm the type used.

TOSHIBA PROJECTOR CONTROL PANEL

STATIC CONVERGENCE ADJUSTMENT (With the Control Panel)

Do not press undesignated key. Pressing any undesignated key can

cause malfunction and adjustment fault. Should the key be pressed by

mistake, turn power off and turn it back on again.

During adjustment, should the screen image be abnormally disfigured

due to static electricity and other cuases, do not have adjustment

status stored, and be sure to turn power off.

Operate the Remote Control towards the PTV screen. If directed other

than to the PTV screen, the Remote Control does not function.

Unless the CONV ADJ SW is ON, remote control operation is not

acceptable. At the time of shipment, the SW is set to ON. If remote

control is not accepted, check status of this SW.

Direct the remote control towards the PTV screen and keep the Test

Key pressed down for approxiamtely 3 seconds. The adjustment

mode should appear on the screen and the screen turns into the green

test pattern.

On the screen, the cross pattern and the square frame line will be

projected. However, due to the TV mask, the up/down lines cannot be

seen.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 127 128

Keine Kommentare

Sega Sega Rally 2 Bedienungshandbuch Seite 56